Sometimes you may want to ensure that the router’s WAN speed is performing according to specifications. Using Speedtest.net and other online speed test websites will give you an indication of the speed up to a certain level, but for a more accurate assessment, you can try the following using iPerf.
Check out the video and step by step instructions below:
Here is the topography of our test environment we will use as an example.

Step 1: Log into each router and check the WANs are online.
Step 2: For DrayOS 4 routers, navigate to NAT > Port Redirection and create a port forwarding rule on each router to forward port 5201 to the IP address of the PC that will be running iPerf.

For DrayOS 5 routers, go to Configuration > NAT and select the Port Forwarding tab.

Step 3: Download iPerf from this website: https://iperf.fr/iperf-download.php#windows
Step 4: Extract the contents of the zip file to a new folder on the C:\ Drive of both PCs. In this example we have named the folder iperf3.1.1_32. One PC will act as the server and one as the client, but these can be reversed later if you want to run a test in the opposite direction.

Step 5: On the server PC, open command prompt and use the “cd” command to navigate to the iperf3.1.1_32 directory, then enter iperf3 -s (which will put it in receive mode). It should respond with “Server listening on 5201”.

Step 6: On the client PC, also open a command prompt and use the “cd” command to navigate to the iperf3.1.1_32 directory, then enter iperf3 -c then the WAN IP address of the server router, which in our example is 106.69.81.191.

After hitting enter, the transfer will begin, showing transfer and bandwidth rates.

Further tests:
- Reverse direction (by changing the server and client roles) to confirm the initial result.
- Enable Hardware Acceleration if available on the router/s and try the test again
Other iPerf command options:
General Options (Any Mode)
- -p [port]: Connects via a specific port instead of the default port 5201.
- -V: Outputs extra details and verbose data during the test.
- -f [kKmMgG]: Changes report format (e.g., m for Mbps, g for Gbps).
- -v: Displays the current software version.
Client-Specific Options (Machine Initiating Test)
- -t [seconds]: Sets test duration. Default is 10 seconds.
- -i [seconds]: Changes the pause time between interval reports. Default is 1 second.
- -R: Reverses traffic direction. Server sends data, client receives.
- -u: Switches protocol from default TCP to UDP.
- -b [bandwidth]: Limits target bandwidth for UDP tests (e.g., -b 100M).
- -P [number]: Runs multiple parallel data streams simultaneously to stress-test bandwidth.
- -4 or -6: Forces the test to use IPv4 or IPv6 addresses only.
Server-Specific Options (Machine Listening)
- -s: Runs the machine in Server Mode to wait for connections.
- -D: Runs the server quietly in the background as a Windows Service.
- -1: Exits the server program automatically after finishing exactly one test.
Example Commands
- Run a 30-second TCP test using 5 parallel streams:
iperf3 -c <Server_IP> -t 30 -P 5
- Run a UDP test targeted at 500 Mbps:
iperf3 -c <Server_IP> -u -b 500M
Published 5/2/2026 – HL
Updated 20/5/2026-HL