This is the start of a new Series of DrayOS 5 routers from Draytek. The Vigor 167 was introduced with limited capacity as a bridge modem and entry level router . Now the Vigor 2136 will be introduced in 2026 and will be the replacement of Vigor 2135 series.
To start with , here is the WAN configuration . This model will have 2 Ethernet WANs and 2 Wifi WANs but as all single WAN routers , there will be only one WAN active at any time.
Short Video here – 2.5 Mins
Step 1:
Go to Configuration>> Physical Interface
Enable Ethernet WAN – speed is by default “auto negotiation”
Fig 1

Fig 2
But the speed can be changed to 2.5G – 1 G – 100M full and Half duplex for fine tuning
Fig 3
If a second WAN is needed then port P1 can be converted from LAN to WAN

Step 2:
Go to Configuration>> WAN
Select the needed WAN and click on “ Edit ”
Fig 4

Fig 5
Enable the profile and then select the Ipv4 Connection type eg PPPOE or DHCP- Static

Fig 6
If necessary, set the advanced mode to “on ” before checking the MTU and WAN Connection Detection

Step 3:
Go to the Dashboard and check the WAN1 settings- the WAN IP should be in green
Fig 7

Edited by HL 3 Sept 2024
